Size guide
SIZE GUIDE
Below are the methods for measuring the size of your rings, bracelets and necklaces,
Measure your ring size
Method 1 - Use one of your rings
a - Measure the inside diameter of your ring in millimeters.
b - Refer to the table below to find out your ring size.
Method 2 - Use a tape measure or string
a - Take a tape measure or a piece of string.
b - Mark a first line on your starting point, then wrap your measuring tool around your finger and note the closing point. Make sure that your measuring tool is not too tight, nor too loose.
c - Take the size in millimeters and refer to the table below.
Always choose the larger size if in doubt between two measurements.
CORRESPONDENCE TABLE
Measure your necklace size
The size of necklaces and chains is expressed in centimeters, and corresponds to the total length.
Take a tape measure or string and measure your neck circumference to get your necklace size.
Choose sizes between 38 and 42 cm to wear a choker. For a looser necklace, choose a size between 42 and 50 cm.
To wear a necklace as a sautoir, choose lengths from 60 cm .
Measure your bracelet size
Flexible bracelet
In the description of each bracelet we indicate the total length of the bracelet; your wrist circumference must be less than this dimension.
Measuring your wrist circumference: To measure your wrist circumference, take a tape measure or a simple piece of string and wrap it around the base of your hand, without tightening it too much. Mark the point where the tape meets and measure the length.
For ease, we recommend adding about 2 cm.
Rigid bracelet (Bangle)
a - Your hand measurement is also important, measure your palm size as shown below:
b - Then refer to the correspondence table below:
For the open bangle, refer to your wrist size, as you will be putting it in through the wrist. Open bangle bracelets are also slightly adjustable, so don't choose them too large.